When the heat goes out or the air conditioning stops working, the first question is not who to call next week. It is who can scope the problem on the call, tell you what it costs, and get a visit on the calendar. That is what we do for Canby. Whether the system is a furnace that won't light, a heat pump that stopped keeping up, or a first-time cooling install in a home that never had one, the call gets answered by someone who knows the work and can walk you through what comes next.
We cover residential and commercial heating and cooling throughout the area. Property managers dealing with a tenant without heat, business owners whose rooftop unit has gone down, and homeowners facing a system that is simply too old to repair economically all reach us the same way.
Call (971) 459-8956 and we will scope the job on the phone before anything is scheduled. We are available every day from 8:00 AM to 9:00 PM.
Most calls start with a symptom, not a diagnosis. The furnace runs but the house stays cold. The AC cycles on and off without cooling anything. One room is comfortable and the next is not. Those descriptions are enough to start a conversation, and that conversation is where the visit gets shaped.
A rooftop unit failure at a small commercial building creates a different kind of urgency than a home call. Employees and customers notice immediately, and the business cannot simply wait. We handle commercial RTU service and replacement, and the diagnostic process is the same as it is for residential equipment: identify the fault, explain what the repair involves, confirm the cost, and get it resolved.
The air handler moves conditioned air through the duct system. When the blower motor is failing, the symptom is often weak airflow at every register rather than at one or two. The motor may also run louder than it used to, or cycle on and off without completing a full run. A visit covers the motor, the capacitor, and the belt or direct-drive connection, and the system is tested before the visit ends to confirm airflow has returned to where it should be.
A dirty evaporator coil reduces how efficiently the system transfers heat, and a coil that has been running dirty long enough can develop a refrigerant leak. The result is an AC that runs longer than it should, struggles to reach the thermostat setting, or starts producing warm air. Coil cleaning is part of a thorough cooling tune-up, and a coil with physical damage gets assessed for repair or replacement depending on its condition and the age of the system.
Weak airflow is one of the most common complaints we hear, and it rarely has a single cause. A clogged filter is the simplest explanation, but a failing blower motor, a collapsed duct section, or a blocked return can all produce the same symptom. We trace the problem through the system rather than replacing parts at random. If the duct system turns out to be the issue, we seal or replace the affected sections and test the result.
Wildfire seasons across the Pacific West Coast have made indoor air quality a practical concern rather than a luxury upgrade. Standard HVAC filters are not built to capture the fine particulates that smoke carries. A MERV-13 capable upgrade, whether a higher-rated filter in the existing slot or a media cabinet installed in the duct system, makes a measurable difference in what circulates through the home. We assess whether the air handler can support a denser filter without straining the blower, and recommend accordingly. Whole-home humidifier and dehumidifier installation also falls within what we handle for homes where humidity control is a seasonal issue.
Hydronic heating systems circulate hot water through radiators or radiant panels to heat the living space. When a boiler is losing pressure, failing to fire, or heating unevenly across zones, the diagnostic process follows the system from the heat source through the distribution loop. We service and repair hydronic space heating systems, including zone valve and circulator pump issues, and we explain what the repair involves before any parts are ordered.
Heating and cooling calls from rental properties come with a layer of coordination that a homeowner's call does not. The person who calls is often not the person who will be home when the technician arrives. The tenant may have a work schedule that limits access. The invoice goes to the owner or the management company, not to whoever lives there.
We work through that without making it complicated. The scope and the price are settled with whoever is managing the property. Access arrangements for the tenant are confirmed before the visit is scheduled. The system is tested at the end of the visit and the result is reported back to whoever placed the call.
If you manage several properties in and around Canby, call once and we can discuss how to handle multiple addresses efficiently. The process does not change based on how many units are involved.
A home in a small town like Canby often carries equipment that has been in place for a long time. Some of it is still running because it was built to last. Some of it is running because nobody has looked at it closely enough to know it should not be.
Older systems reach a point where the parts needed to repair them are no longer manufactured, or where sourcing them adds significant cost and delay to a job that a newer system would handle without issue. We check parts availability before quoting a repair on older equipment, and we lay out both options clearly: what the repair costs, what a replacement costs, and what makes sense given the age and condition of what is already there.
Homes that have been extended or reconfigured since the original HVAC system was installed often have rooms the duct system was never designed to serve. A bedroom addition that draws from a duct branch sized for a smaller footprint, or a converted garage that has no supply at all, produces the kind of uneven temperature complaints that a tune-up alone will not fix. We assess the distribution system as part of any call where the symptom points to it, and we can quote duct modifications or zoning upgrades that bring the whole home into balance.
Pricing an HVAC job starts with what the system is doing and what the visit will need to cover. A straightforward repair on a common fault costs less than a repair that requires accessing a component deep in the air handler, or one where the part has to be sourced before the work can be completed. A diagnostic visit that reveals a different fault than the symptom suggested changes the scope, and we explain that before any additional work is authorized.
The difference between a repair and a replacement is the other thing that moves a quote significantly. When a repair addresses a single component on a system that is otherwise in good condition, it is usually the right answer. When the repair cost approaches what a replacement would run, or when the system has multiple components that are close to failing, replacement is worth considering. We lay both options out plainly so the decision is yours to make.
You get the price on the phone before the visit is scheduled. Ask what the quote covers and you get a straight answer.
Call (971) 459-8956 to get started.
When you call, the first thing we establish is what the system is doing and what the visit will involve. From there, we schedule based on what the calendar allows. For urgent calls, including a home with no heat or no cooling at all, we take those as short-notice work and get a visit on the calendar as quickly as possible. We are available every day from 8:00 AM to 9:00 PM.
If a tenant is in the property and the business or household cannot function without the system running, tell us that on the call. We factor it into how the visit gets scheduled and what the technician prioritizes when they arrive.
We do not ask you to fill out a form and wait for a callback before the system gets looked at. For the full list, go to our HVAC service list.
Call (971) 459-8956 and the conversation starts immediately.
We serve Canby and the surrounding areas throughout Clackamas County. If you are in one of the towns nearby, call and we will confirm coverage at your address.
Communities we cover include:
Whether the property is in Canby itself or in one of the neighboring communities, the process is the same. The job is scoped on the call, the price is confirmed before the visit, and the work is carried out to code.
That is something to confirm on the call, since it depends on how the work is scheduled and what each address requires. We can discuss billing arrangements when you call to set up service across multiple properties.
Yes. A ductless mini-split system is a practical option for homes that were built without central air conditioning and have no duct infrastructure to work with. We assess the layout of the home, recommend the right number of indoor units and zones, and handle the full installation.
Call (971) 459-8956 and describe the property and we can walk through what a first-time cooling install would involve at your address.
Call (971) 459-8956 and give us the address.
We will confirm whether the property is within the area we cover and what the service call involves. Pricing is discussed on the call before anything is scheduled.
In a town of this size, a lot of the housing stock has been in place long enough that equipment is reaching the end of its service life. Furnaces that short-cycle, heat pumps that have lost refrigerant charge, and duct systems that were never properly sized for additions or remodels are the calls we see most often. First-time cooling installs are also coming up regularly as summers in the Pacific Northwest have pushed more homeowners to add AC for the first time.
A first-time cooling installation involves more work than a replacement because there is no existing equipment to remove and the system has to be sized and configured from scratch. We assess the property, determine the right equipment type and capacity, and explain what the installation involves before anything is scheduled. Properties without ductwork are candidates for ductless systems.
Yes. We confirm access arrangements with whoever is managing the property before the visit is scheduled, and the technician works around the tenant's schedule where possible. For work that requires the system to be shut down temporarily, we let the tenant know in advance what to expect and how long the system will be offline. The scope and the invoice go to whoever placed the call, not to the tenant.
Comfort problems don't wait, and neither do we. You will always know who to call if you need us again.
Call Lake Oswego HVAC Company at (971) 459-8956, every day from 8:00 AM to 9:00 PM.
The price is confirmed before anything is scheduled, and there are no forms to fill out before someone looks at your system.
Just as close, we take heating and cooling work in: Wilsonville, Oregon City, West Linn, Woodburn. Browse our full list of towns.
We cover heating and cooling for homes, rental properties, and commercial buildings throughout Canby and the surrounding Clackamas County area. Whether you need a quick repair, a full system replacement, or a first-time cooling install before summer, we scope the job on the call and give you a price before anything is scheduled. The table below lays out what each service covers and who it fits best. Call us to talk through your situation and get the work on the calendar.
| Service Type | What's Included | Common Needs | What to Keep in Mind |
|---|---|---|---|
| Thermostat & Smart Controls |
| Homes where the thermostat is misreading temperature or failing to communicate with the system | A smart-control upgrade paired with a heat pump gives room-by-room temperature management that a basic single-stage thermostat cannot match. |
| Emergency HVAC Service |
| Households or buildings with a system that has stopped working entirely | We are available every day from 8:00 AM to 9:00 PM. Call as soon as the problem starts so we can get the visit on the schedule quickly. |
| HVAC System Installation & ReplacementMost Popular |
| Homeowners, landlords, and property managers whose system has reached the end of its service life | Oversized equipment short-cycles and wears out faster. Undersized equipment runs constantly. We match the unit to the space before the install date is set. |
Call us to talk through your heating or cooling situation and get a price before anything is scheduled.
(971) 459-8956